WiFiBee/Wifly Setting Tool Released
TinySine WiFiBee or Wifly is a very popular wireless module. We use it on our WiFi relay and Lazybone series wireless switch. Some customers meet problems when they try to configure it. It's not a easy job in the past. You need sending the AT commands. If you are not an engineer. It's a little difficult.
Now, we released a simple WiFiBee setting tool. You can use it to set your wifibee/wifly easily!
Simple 6 steps:
- You need a USB adapter. Plug your WiFibee or Wifly on your USB adatper
- Connect the USB adatper to your computer.
- Install FT232RL drivers. A new COM port will appears in the device manager.
- Open the TinySine WiFibee setting tools.exe. Select the correct COM port.
- Input your network SSID, Password, and assign a valid IP to the WiFi module.
- Click writing configuration. All done!
After configuration. Your WiFibee module should joined your wifi network. D1 slow Blink. If you want reset the module to factory setting. Just click "Factory Reset" button.
Download: