FTDI Basic Breakout 5V/3.3V With USB cable

FTDI Basic Breakout 5V/3.3V With USB cable
Product Code: G4CB12AF4E1115
Reward Points: 12
Availability: 457
Price: $6.90

5 or more $6.80
20 or more $6.20
100 or more $6.05
   - OR -   

The newest revision of our FTDI Basic, which use a  6-pin header on the bottom,  smaller and more compact.Functionality has remained the same. This is a basic breakout board for the FTDI FT232RL USB to serial IC.
The pinout of this board matches the FTDI cable to work with official Arduino and cloned 5V/3V Arduino boards.
It can also be used for general serial applications. The major difference with this board is that it brings out the DTR pin as opposed to the RTS pin of the FTDI cable. The DTR pin allows an Arduino target to auto-reset when a new Sketch is downloaded. This is a really nice feature to have and allows a sketch to be downloaded without having to hit the reset button. This board will auto reset any Arduino board that has the reset pin brought out to a 6-pin connector.

The pins labeled BLK and GRN correspond to the colored wires on the FTDI cable. The black wire on the FTDI cable is GND, green is CTS. Use these BLK and GRN pins to align the FTDI basic board with your Arduino target.

This board has TX and RX LEDs that make it a bit better to use over the FTDI cable. You can actually see serial traffic on the LEDs to verify if the board is working.

This board was designed to decrease the cost of Arduino development and increase ease of use (the auto-reset feature rocks!). Our Arduino Pro boards and LilyPads use this type of connector.

FDTI BASIC1.jpgFDTI BASIC2.jpg

 

 

Documents:

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below:



Powered By Tinyos
Tinysine (Tinyos) Electronics © 2014